Adjusting the clip to the LED lamps and configuring the flexible arm:

– The tabletop to which the clip will be attached should not have more than 3 cm thick. (The clip handles are covered with a layer of sponge to protect furniture from scratching).
– The LED lamp holder can hold the “whole” lamp including the transparent part/diodes. You can also grab the aluminum housing with proper setting of the center of gravity flexible arm.
– Depending on the flexible arm setting and the appropriate bend, we can adjust the number of clips required for the lamps. (This will be described after the list of points).
– Flexible bending arm influences also the height of the lamp to the tabletop, picture A when the arm is bent in the letter “C” it is 25cm. In the case of picture B and bending and denting at three points is 40cm.
– The deeper the plants are into the countertop/shelf/windowsill, the further the clip arm has to reach – this causes shortening the distance between the countertop and the lamp and smaller than the plants. The opposite situation occurs when the plants are closer to the clip that attaches to the tabletop.
– The lamp holder is rotary, it can be turned sideways, moved up and down and adjusted to the current configuration of the flexible arm.